DRP Stripper Plus 5 Gallon-Paver & Wood Coating Remover

DRP Stripper Plus is a professional, sprayable paver coating remover that is
BOTH eco-friendly and very effective. Until now, applicators have often been left
with the unwelcome choice of using a coating remover that is flammable, or
contains harsh chemicals. Now, that has all changed. With DRP Stripper Plus,
you have a coating remover that has superior performance and is so easy to
use.

DRP Stripper Plus Sprayable Paver & Wood Coating Remover is a
non-hazardous coating remover that has ultra-low V.O.C. DRP Stripper Plus
can be used on pavers, and other similar surfaces to remove various coatings
and finishes. It does not contain any methylene chloride, methanol, NMP,
petroleum distillates or caustic. DRP Stripper Plus can be safely used on
pavers, brick, concrete, natural stone, wood and other surfaces.

Before general use, it is imperative to test on a small, inconspicuous area to
determine compatibility, required dwell time, coverage and desired results. The
user shall determine the suitability of the product for its intended use(s), and
user assumes all risk and liability whatsoever in connection therewith. Work in
small, manageable areas, rinse and allow surface to dry before general
application.

1. Shake well before use. Cover/protect/mask areas with plastic sheeting where
removal is not required. Protect surrounding surfaces, plants and vegetation.
Rubber gloves and safety glasses are recommended for eye and skin protection.
2. DRP Stripper Plus is a ready to use product. Do not dilute. 3. Apply liberally
onto a dry surface using a plastic tank sprayer, roller, brush, or airless sprayer.
Coverage varies depending upon the type of product being removed and
application method, but is generally between 50 – 100 square feet per gallon.
DRP Stripper Plus should be applied between 60F – 80F for best results. 4.
Allow sufficient time to penetrate the coating. Depending on type of coating being
removed and number of coats, dwell times can vary. Check applied area at 30
minutes – 4 hours, then periodically thereafter. In some circumstances the white
DRP Stripper Plus will turn clear which usually indicates the coating is ready for
removal. It stays active up to 12 hours for tougher coatings. 5. Once DRP
Stripper Plus has softened the coating from the surface, remove coating using
a pressure washer. 6. Rinse any remaining residue with clean water. A second
application may be necessary and/or longer dwell time. 7. Clean all applicators
and equipment with soap and water. Do not store or collect remover and/or
coating residue in metal containers. Use plastic containers only. 8. Dispose
according to local, state and federal regulations.

Wear neoprene, nitrile, 4H or other impervious gloves. Wear an impervious
apron, boots and other protective clothing. Wear chemical resistant safety
goggles and/or face shield unless a full-face piece respirator is used. Do not
wear contact lenses. For spray applications and other jobs where the
recommended exposure limit may be exceeded, an approved full face piece
particulate respirator may be required. Select in accordance with OSHA
1910.134 and good industrial hygiene practices